August 27, 2017

Neutral Black & White Prints

In 2012 I switched from a Canon Pro 9500 to an Epson R3000 printer. The main reason was an extra gray ink and Epson's Advanced Black & White mode. The switch proved to be a good choice as the Epson R3000 creates neutral, high quality black & white prints. A neutral black & white print contains gray tones without any colour casts. Neutral is also a matter of personal taste. So when is neutral really neutral?

The Epson R3000 has nine ink cartridges. During the print process it uses eight inks. An additional black ink is needed to support printing on gloss and matte papers.

Epson R3000 ink set

Epson R3000 ink set

Two gray inks (Light Black and Light Light Black) contribute to the Epson’s black & white print capabilities. However, it’s not possible to print al gray tones with only three black inks, so it also uses Yellow, Vivid Light Magenta and Light Cyan for black & white printing (Vivid Magenta and Cyan are not used by Epson’s Advanced Black & White mode). The use of color inks affects the neutral look of a print. Personally I think that the default neutral setting results in prints that are a bit too cool for my taste. Overall the prints have a slightly bluish cast in different viewing conditions and with different papers. Fortunately, it’s easy to fix this.

Go to the Print Settings dialog and click on Advanced Color Settings. At Color Toning you can choose a tone: Neutral, Cool, Warm or Sepia. I'm not a fan of toning my prints, but Color Toning is a great way to tune the neutral look of your prints by choosing your own values. By making small adjustments you can make a print warmer or cooler, without adding a clear color tone to the print.

I wanted a slightly warmer print so I started with a horizontal value of 4 and a vertical value of 2. I made three additional prints and increased the vertical value by 2 for each print. I compared the prints side-by-side and choosed my favorite setting. When comparing the prints it’s important to use a neutral light source. I'am using a Color Confidence Grafilite viewing unit to evaluate my prints.

My default settings are now: horizontal 4 / vertical 2 for white papers and horizontal 4 / vertical 8 for warmer papers.

Print Settings

Print settings with toning control


No comments

Older articles:

August 23, 2017

What I Don't Like About My Epson R3000

Don’t get me wrong: I really like my Epson R3000. The printer is capable of making high quality prints, but it has a nasty habit. Once in a while it spoils a lot of expensive ink.

Continue reading

September 7, 2016

Tecco Baryt Ivory Fine Art Paper

I discovered a new fine art paper. I usually print my black and white images on Ilford Gold Fibre Silk, but sometimes I feel the need to try something new. I dug into my sample packs and found two sheets of Tecco Baryt Ivory 290 gsm. After two test prints I was pleasantly surprised.

Continue reading

January 3, 2015

Kodak Film Presets For Lightroom

The Kodak Film Presets for Lightroom emulate the monochrome films: Kodak T-Max 100, Kodak Plus-X 125, Kodak Tri-X 400, Kodak T-Max 400, Kodak T-Max P3200.

Continue reading

January 3, 2015

Ilford Film Presets For Lightroom

The Ilford Film Presets for Lightroom emulate the monochrome films: Ilford Delta 100, Ilford FP4 Plus 125, Ilford HP5 Plus 400, Ilford Delta 400, Ilford Delta 3200.

Continue reading